Using the Never Touch™ Paint-N-Mount System

 

Do prep-work on fish and never touch it!
Paint fish, then clear coat it and never touch it!
Mount fish to driftwood or plaque and never touch it!


Never Touch™ features include: a special blend of ultra-strong materials, engineered to handle any fish you attach to wood, self-tapping wood screw molded into center of the rod plug, materials are lacquer and acetone resistant, non-rusting, provides 3D effects never before possible, ultra-strong anchor bars with screw slots.


Simple Instructions:

  1. Match the rod plug diameter to the wood boring bit ( this is for the plug to seat into the wood.)

  2. Drill the rest of the way with a 3/8 inch bit.

  3. Screw the rod into the back of the fish, making sure to hid wood. Use rod handgrip for better control.

  4. Drill screws with washers through the anchor bar slots.

  5. Once the rod is attached to the fish you never have to touch the fish again.

  6. After the fish is complete, remove the handgrip and slide the rod through the hole in the driftwood or plaque. Grasp the rod opposite side of wood with fish facing you, turn the rod to the correct position, and pull the plug into the hole to lock in position. Thread a 3/8 inch nut to the back of the wood and tighten with open-end wrench.

  7. Cut off remaining rod, flush with the 3/8 inch nut.

  8. Hang finished fish on the wall and telephone customer for pickup!

Note: Do not over tighten, use only nylon nut supplied.


  Go Back